The When and Whys of Wood Notching
... , the nails won't be stretched out far enough to effectively counter any substantial rotating force. And remember that each nail is essentially puncturing a hole in your wood, reducing its strength, so although some are necessary to provide adequate friction, too many will cause the wood to split. Solution: Notch it. And remember, notches don't have to be deep. Again, they do not have to be deep! At least not in most cases. In the above example, notching the vertical 2×4 even a quarter-inch would sufficiently lock the horizontal one in place, and with an additional screw or ... the board. Bear in mind that depending on position, a board is only as strong as its weakest, or should I say thinnest point. Say you wanted to join two 2×4's in the above "cross" fashion, and wanted to notch it so as to make the joint flush on the outside faces. This would require you to notch both 2×4's halfway and slot them into each other. While this is perfectly fine for non-structural uses, this kind of notching would not be recommended for structural members of any kind. As far as the structure is concerned, these are no ...
Tags: structural members | notching tips | wood notching | wood notching tips | notch work | notching wood |
Tags: structural members | notching tips | wood notching | wood notching tips | notch work | notching wood |